Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Unscrew the bolts -2- (5x).
– Carefully lift out the sun blind housing -1-.
Installing
– Hold the cover -1- open.
– Pull the sun blind -2- slightly out of the housing.
– Slide the sun blind housing -1- onto the door frame, inserting
the shafts in the sun blind housing -1- such that the ends of
the shafts are visible.
Note
The sun blind must not retract into the housing.
– Use the bolts -2- (5x) to screw on the sun blind housing. 3 Nm.
– Plug in the connector -4- to the sun blind control unit.
– Plug in the connector to the window regulator motor.
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
202 Rep. gr.70 - Trim, insulation
To Next Page
Loading...
