Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– A second mechanic is required for implementation of the next
two steps.
– Open the cover of the sun blind housing again and pull out the
blind slightly.
– Use the switch in the roof module to extend the shafts (approx.
150 mm).
– Pull out the sun blind until it can be engaged at the shafts.
– Fasten the clips -2- (2x).
– Use the switch in the roof module to retract the sun blind.
– Install the window regulator motor ⇒ Rep. gr. 58 .
– Close the window.
The electric sun blind must be re-adapted; proceed as follows.
– Fully extend the sun blind by way of the switch in the roof
module and keep actuating the switch for at least a further 6
seconds. This starts an automatic initialisation process.
– Install the door trim ⇒ page 189
2.18.2 Moving electric sun blind with defective
drive unit
Sequence of operations
– Remove the door trim ⇒ page 189 .
– Remove the insulation ⇒ page 192 .
– Sever the cable ties -2- at the conduits -5- and at the wiring
harness.
– Detach the conduits from the sun blind drive unit -1-.
• The flexible shafts of the sun blind drive unit are then visible.
– Clamp the end of one of the flexible shafts in the drill chuck of
a power screwdriver.
• Turning anti-clockwise extends the sun blind.
• Turning clockwise retracts the sun blind.
– Once the sun blind has moved slightly, apply the power screw‐
driver to the second shaft so that the sun blind moves evenly.
2.18.3 Removing and installing electric sun
blind drive unit
Special tools and workshop equipment required
♦ Torque wrench -V.A.G 1783-
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
2. Rear door trim panels 203
To Next Page
Loading...
