Audi A8 2003 - Page 219

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
2.18.4 Removing and installing side roller blind
control unit -J719-
– Remove the door trim ⇒ page 189 .
– Remove the electric sun blind housing ⇒ page 200 .
– Remove the electric sun blind drive unit ⇒ page 203 .
– Release the side roller blind control unit -J719- -8- and slide
the control unit -J719- -8- out of the mount.
Note
The software version is indicated as a three-digit number in small
print after the genuine part number. The vehicle must not be fitted
with a software version less than 004.
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
2. Rear door trim panels 209