Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Screw on the assembly mount. 3.5 Nm.
– Tighten the bolts -3-. 4 Nm
– Tighten the nuts -3-. 4 Nm.
– Fit the cable ties -2- at the conduits -5- and at the wiring har‐
ness.
– Fit the cable ties at the same positions as those unfastened or
severed prior to removal.
– Plug in the connector -4- to the electric sun blind drive unit
-1-.
– Remove the guide sleeves -T40077- -1-.
– Attach the protective sleeves ⇒ Item 2 (page 207) .
– The protective sleeves must not rest on the door frame, but
must rather be pushed through the hole as far as the end caps
⇒ Item 3 (page 207) .
– Install the electric sun blind housing ⇒ page 200 .
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
208 Rep. gr.70 - Trim, insulation
To Next Page
Loading...
