Audi A8 2003 - Page 217

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
1 - Shaft
2 - Protective sleeves
3 - End caps
4 - Hose clamps
5 - Clamps
❑ The clamps face in‐
wards on vehicles with
long wheelbase (as
shown in Fig.).
❑ The clamps face out‐
wards on vehicles with
short wheelbase.
6 - Penetrations in assembly
mount
7 - Rubber grommet
8 - Guide tubes
9 - Assembly mount
10 - Retainer tabs
– Attach the guide sleeves -1-.
– Install the rear assembly mount ⇒ Rep. gr. 58 . In doing so,
guide the shafts from underneath into the guide sleeves -
T40077- -1-.
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
2. Rear door trim panels 207