Audi A8 2003 - Page 216

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Unscrew the bolts -3-.
– Pull the electric sun blind drive unit -1- with the guide tubes
-2- out of the assembly mount -4-.
Installing
Note
New components: Remove the electric sun blind drive unit from
the packaging at both guide tubes at the same time.
– Slide the electric sun blind drive unit -1- with the guide tubes
-2- into the assembly mount -4-.
– Loosely screw in the bolts -3-.
– Turn the assembly mount onto the back.
– Slip the rubber grommets -7- (2x) over the guide tubes -8-.
– Press the rubber grommets -7- (2x) into the penetrations -6-.
– Vehicles with long wheelbase: Slide the clamps -5- (2x) over
the guide tubes -8- such that they face one another (Fig.).
– Vehicles with short wheelbase: Slide the clamps -5- (2x) over
the guide tubes -8- such that they face outwards.
– The clamps -5- must engage with the retainer tabs -10-.
– Insert the thread of the clamps -5- in the assembly mount -9-.
– Loosely screw in the nuts of the clamps -5- on the front.
– Attach the end caps -3- (2x).
– Position the hose clamps -4- (2x) such that they face outwards
(Fig.).
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
206 Rep. gr.70 - Trim, insulation