Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Remove the rear assembly mount ⇒ Rep. gr. 58 .
– Unscrew the nuts -3-.
– Turn the assembly mount onto the back.
– Unfasten the hose clamps -4- (2x).
– Lift off the protective sleeves -2- (2x).
– Lift off the end caps -3- (2x).
– Detach the clamps -5- (2x) over the guide tubes -8-.
– Pull the rubber grommets -7- (2x) out of the penetrations -6-.
– Detach the rubber grommets -7- (2x) over the guide tubes
-8-.
1 - Shaft
2 - Protective sleeves
3 - End caps
4 - Hose clamps
5 - Clamps
❑ The clamps face in‐
wards on vehicles with
long wheelbase (as
shown in Fig.).
❑ The clamps face out‐
wards on vehicles with
short wheelbase.
6 - Penetrations in assembly
mount
7 - Rubber grommet
8 - Guide tubes
9 - Assembly mount
10 - Retainer tabs
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
2. Rear door trim panels 205
To Next Page
Loading...
