Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Release the retainer tabs -1- of the coin tray.
– Pull the coin tray out of the dash panel -arrow-.
– Unplug the connector on the back of the coin tray.
– Remove the heating duct in the driver side footwell.
– Unplug the connectors -1-.
– Unclip the connector -5- at the relay and fuse carrier.
– Screw out the bolts -3-.
– Disengage the retainer -4- of the relay and fuse carrier at the
side guide -arrow-.
– Detach the relay and fuse carrier -2- and set it down in the
footwell with the wires connected.
– Screw out the bolts -1- of the left fuse box -2-.
– Release the retainer tabs -arrows- and detach the fuse box
from the central tube for the dash panel (leave the wires con‐
nected).
– Release the securing clip -arrow 1- at the left CAN connector.
– Press the retainer tab -arrow 2- and detach the CAN connector
-T46a- inwards (leave the wires connected).
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
236 Rep. gr.70 - Trim, insulation
To Next Page
Loading...
