Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
♦ Removal wedge -3409-
♦ Feeler gauge
4.2.1 Dismantling
Note
All cable ties unfastened or severed on removal are to be re-at‐
tached in the same position on installation.
– Remove the dash panel ⇒ page 224 .
– Set down the dash panel with central tube on a soft surface.
– Unclip the cap -1- with a 0.35 mm feeler gauge -2- from the
centre defroster vent -arrow-.
– Prise out the sunlight penetration photosensor -G107-
-Item 3- and unplug the connector.
– Screw out the bolt -1-.
– Prise the centre defroster vent -2- as shown out of the dash
panel using the removal wedge -3409- .
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
242 Rep. gr.70 - Trim, insulation
To Next Page
Loading...
