Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Screw out the bolts -1- and -2- at the mount for the front pas‐
senger's airbag.
– Unfasten the cable tie on the driver side at the mount for the
relay and fuse carrier.
– Take the wiring harness out of the mount at the central tube
on the front passenger side.
– Take the central tube out of the dash panel.
4.2.2 Assembling
Assemble in reverse order, paying attention to the following:
Note
♦
Re-attach all cable ties in the same locations on installation.
♦
Replace self-locking nuts and bolts when performing assem‐
bly work.
– Secure the bolts -1- and -2- with locking fluid.
4.2.3 Tightening torques
Component
Nm
Mount for front passenger's airbag to central
tube mount
4
1)
Front passenger's airbag to mount 4
Dash panel to At top 2
Central tube
On side 4
1) Secure with locking fluid
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
244 Rep. gr.70 - Trim, insulation
To Next Page
Loading...
