Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
1 - Backrest
– Disengage the fasten‐
ing strips -8- (2x).
– Unscrew the bolts -3-
(4x).
– Detach the fitting trim
panels -2- (2x).
– Prise out the backrest
fittings -4- (2x) at the
guides -9- (4x).
– Tilt the backrest -1- for‐
wards onto the seat.
– Press the padding aside
and carefully pull the
wiring harness -2- out of
the seat pan -8-.
– Detach the backrest -1-.
♦ Installing
– On the tunnel side, po‐
sition the spacer -5- on
the lower guide -9- such
that the spacer is flush
with the guide -9-.
– Always replace the bolts
-3- (4x).
– Re-cut the threads in the
backrest frame before
inserting the bolts -3-
(4x).
– Continue installing the
backrest -1- in the re‐
verse order of removal.
– Memory seat: After in‐
stalling the seat in the
vehicle, perform back‐
rest/seat basic setting.
2 - Fitting trim panels (2x)
3 - Bolts (4x)
❑ Tightening torque 34 Nm
4 - Backrest fittings (2x)
5 - Spacer, tunnel side only
6 - Wiring harness
7 - Seat pan
8 - Fastening strips (2x)
9 - Guides (4x)
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
290 Rep. gr.72 - Seat frames
To Next Page
Loading...
