Audi A8 2003 - Rear seats

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
1 - Seat fan connector (3–pin)
2 - Rear footwell light connec‐
tor
3 - Backrest connector (8–pin)
4 - Backrest heating connector
(2–pin)
5 - Locating clip
♦ Refer also to Fig., wiring at
connector console
⇒ Item 1 (page 321) and
Fig., wiring on left side (ex‐
terior view)
⇒ Item 3 (page 323)
♦ The locating clip -5- must
always be fitted from under‐
neath.
♦ If missing, the locating clip
-5- must always be attach‐
ed to prevent cable abra‐
sion on the seat frame.
♦ If missing, the locating clip
-5- must be attached 80
mm (dimension -A-) from
the centre of the binding
clip -6-.
Note
6 - Left binding clip
7 - Right binding clip
8 - Seat heating connector (2–
pin)
Wiring on left side (exterior view)
Note
The detail shows the view from the side.
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
322 Rep. gr.72 - Seat frames