Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
1 - Locating clip
2 - Airbag earth connector (1–
pin)
3 - Locating clip
♦ Refer also to Fig., wiring at
connector console
⇒ Item 1 (page 321)
♦ The locating clip -3- must
always be fitted from under‐
neath.
♦ If missing, the locating clip
-3- must always be attach‐
ed to prevent cable abra‐
sion on the seat frame.
♦ Attaching missing locating
clip -3-
⇒ Item 5 (page 322)
4 - Binding clip
5 - Backrest heating connector
(2–pin)
6 - Backrest connector (8–pin)
7 - Binding clip
8 - Belt buckle connector
Wiring for seat pan motors
1 - Seat angle adjustment motor connector
2 - Seat angle adjustment motor wiring
♦ The cable -2- must be routed above the seat angle adjustment
motor.
♦ The cable -2- is the longer wire.
3 - Seat longitudinal adjustment motor connector
4 - Binding clip
Backrest wiring
Note
The upper detail shows the view from the front.
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
1. Front seats (memory seat, electrically operated seat) 323
To Next Page
Loading...
