Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
1 - Backrest wiring harness
2 - Locating clips (6x)
3 - Backrest adjustment motor
connector
4 - Backrest connector (8–pin)
5 - Backrest heating connector
(2–pin)
6 - Cable guide
♦ The cable must be routed
through the cable guide
and behind the backrest
adjustment shaft.
7 - Lumbar support height ad‐
justment motor connector
8 - Lumbar support height ad‐
justment motor
9 - Cable tie (2x)
1.37.2 Convenience seat wiring
Note
♦
The illustration shows the front passenger's seat, the driver's
seat configuration is a mirror image.
♦
Cable routing and attachment to the seat must be carried out
as shown so as not to damage the wiring harness.
Wiring on left side
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
324 Rep. gr.72 - Seat frames
To Next Page
Loading...
