Audi A8 2003 - Page 338

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
1 - Seat fan connector (3–pin)
2 - Rear footwell light connec‐
tor
3 - Seat occupied sensor con‐
nector (2–pin)
4 - Seat heating connector (8–
pin)
5 - Left binding clip
6 - Locating clip
♦ The locating clip -6- must
always be fitted from under‐
neath.
♦ If missing, the locating clip
-6- must always be attach‐
ed to prevent cable abra‐
sion on the seat frame.
♦ If missing, the locating clip
-6- must be attached 80
mm (dimension -A-) from
the centre of the binding
clip -5-.
Note
7 - Right binding clip
Wiring for seat pan motors
1 - Seat angle adjustment motor connector
2 - Seat angle adjustment motor wiring
♦ The cable -2- must be routed above the seat angle adjustment
motor.
♦ The cable -2- is the longer wire.
3 - Seat longitudinal adjustment motor connector
4 - Binding clip
Backrest wiring
Note
The upper detail shows the view from the front.
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
328 Rep. gr.72 - Seat frames