The Y-Drive Assembly
DSX™ System Service Manual 7-37
To Replace the Belt:
1 Prepare a new belt (Part No. 40000050), which is 998 mm long and placed as
shown in Figure 7-44. The belt should be wrapped around the motor and idler
pulleys. Assemble the idler pulley belt end with a Y-belt adjustable block (Part No.
204010600) using one clamp block (Part No. 204012400) and two M3 x 8 cap
head screws. On the motor end of the belt install the Y-belt fixed block (Part No.
204010500) using one clamp block (Part No. 204012400) and two M3 x 8 cap
head screws. After the blocks are prepared, use Loctite 222 to secure the screws.
Figure 7-44 Y Belt Assembly
To Next Page
Loading...
