230
Loading the bitmap file
(1) Change the file extension of your bitmap file from bmp to ouf manually on the computer. (For
example, image.bmp -> image.ouf) Save the file to your USB flash drive.
(2) Display the [FILE - UPDATE] menu.
(3) Turn F1 to select OUF.
(3) Turn F3 to select the OUF file (image file).
FILE : EXT : LOAD : <DIR> 1/1
UPDATE : =OUF : : image.ouf 101MB
(5) Press F3. All lights on the control panel will turn off. When the images are successfully
loaded to the control panel, the panel lights will turn on again.
Displaying the Loaded Bitmap Images
(1) Open [SETUP - INPUT - ASSIGN] PAGE 3.
(2) Turn F1 to display a bus button.
(3) Turn F2 to select BMP. The created image will appear on the bus button display.
INPUT :BUTTON : TYPE : INV : : 3/6
BUS DISP: =01 : =BMP : =OFF : :
Refer to section 5-3. "How to Display Signal Names on the Bus Section" for more details.