104
Engineering, User & Panel Configuration
Saving a Config File
Sub Enables
The “Sub Enables” list of buttons, to the right of the config files table, allows the user to select
or de-select functions that can be saved with a file.
If the tab next to the enables button is green, this means that the function was included when
the file was originally saved. If the tab is gray, the function is not included when the file was
originally saved. If an enabled function is selected (green), when the config is saved, the
function will be included in the saved config (shown below).
Enables and Sub Enables buttons are found in the in the Engineering, User and Panel Config
menus as well as the Filing System menus.
Merge Enables - this merges enables currently set in the switcher with the enables saved in
the file being loaded (a “logical OR” of the enables).
Override Enables - will override any enables that have been de-selected and turn the enable
On.
To Next Page
Loading...
