GRASS VALLEY MASTERPIECE - Formatfusion3 Tm; Input Formatfusion3 Inputs and Channels

128
Engineering, User & Panel Configuration
FormatFusion3TM
FormatFusion3
TM
The FormatFusion3
TM
parameters allow the user to control or change the aspect of an input
source, or crop an oversized source.
FormatFusion3 would mainly be used to convert a HD source to a UHD source.
Input FormatFusion3 Inputs and Channels
To use FormatFusion3, touch the {Input Setup...} button, then in the menu, select an input by
touching an input row or use the “BNC Input” parameter. Once selected, set the “User Default
Standard” parameter to “No” and set the “Auto Standard” parameter to “On”. This must be
done for each input that requires FormatFusion3.
In the Engineering Config menu, touch the {FormatFusion3...} button to open the menu. The
table at the top of the menu displays the available channels of FormatFusion3.
Each of the channels of FormatFusion3 in the table are individually enabled by setting the
“Enable” parameter to “On”.