236
Effects Dissolve and Squeeze Effects
Bgnd DVE and Mixer DVE
Setting up a Squeeze Effect
With the “Bgnd DVE” enabled and the Program and Preset parameters turned On, You can now
use the Position & Size to re-position the Program tile.
Position and zoom the program tile to the position required for the squeeze effect. The open
the “Shortcuts” menu and save the move as a DMEM.
Use the number pad to save the current state of the system as a DMEM, by entering a memory
number and saving the memory file e.g. enter “100” as the memory file, then select the {Mixer}
button below the number pad and then {Save}. You can use the Effects Dissolve at this point
but in this example Effects Dissolve will setup in the DMEM menu to the saved file.
Program Tile
Preset Tile
Program Tile
To Next Page
Loading...
