282
Stores
Store - Grab
Store - Grab
Another option to generate a Still or Clip is the Store - Grab option; this allows the user to grab
images, video or audio clips from a Crosspoint, Mixer Output, Matte or from another Store.
Touch the menu link button in the menu bar to display the list of Store Menus, then touch the
{Grab} button to open the Grab main menu (as shown below).
Taking a Grab
This example is taking a grab using the most simple method. Using the Grab Crosspoint
parameter (or pop-up selector), select the required still or video source that contains the
images or video content, then using the Grab To Store parameter, select the Store into which
the grabbed information will be placed and press the {Grab Video} button.
If the information that is grabbed is coupled with another Store for a Key, the Grab function will
grab the Key as defined in the crosspoint mapping into the coupled Store.
The minipic at the bottom of the menu will display what is currently grabbed, which will be a
still, or the center frame of a clip.
Grab Options
Single Frame - used to grab a single frame into the Store on press.
Latching Grab - this will latch the grab function and allow the grabbing of Clips. This option is
best used with the Stop When Full to end the grabbing once the Store is full i.e. once all the
available frames in the Store have been used.
Latching Grab is best used for grabbing Video or Audio files. Pressing the {Grab Video} button,
which turns the button green, then pressing latching grab for the required grab time will grab
video only. Pressing the {Grab Audio} button, which turns the button green, then pressing
latching grab for the required grab time will grab will Audio only. With both buttons green,
Video and Audio will be grabbed.
Grab - This will continue to grab while the button is pressed. This will also respect the Stop
When Full.
Preview Grab - This will place a preview of the grabbed image or video into the minipic at the
bottom of the screen.
Note: This is part of the ClipTrax function. Grab Mode has to be set to
“Replace Sub-Clip” for this function to work.
To Next Page
Loading...
Need help?
General
