247
Masterpiece
User Manual
Once a macro has been recorded, the button press sequence that was recorded is displayed in
the Macro Actions table (shown above). Press the {Test Macro} button to test the macro just
recorded.
Pausing a Macro Record Sequence
A Macro can be paused once a record sequence has started. Whilst a Macro is being recorded
the {Macro Record} button is Red. Press and hold the {Macro Record} button and it will turn
Orange indicating that it is Paused. At this point the Button Delay timer is also paused.
Press the {Macro Record} button once. The button will turn Red and the record process will
start once again.
Appending more Macro Actions to a Macro Sequence
Additional macro actions can be added to a previously recorded macro sequence. In the
{Edit…} menu, move the highlight bar to the position above where the action is going to be
inserted, and then press and hold the {Macro Record} button. Again the button will turn Red
and the record sequence will start. When finished press the {Macro Record} button again to
stop recording, and the macro sequence will be added below the highlight bar.
Note: While a macro is paused, Masterpiece can still run multiple other
macros at the Grass Valleye time
To Next Page
Loading...
