73
Masterpiece
User Manual
Aux Buses
Touch the {Aux Buses} menu link button. Aux Bus 1 to 14 are the Grass Valleye as Outputs 1 to
14 (HD video format only) at the rear of the mainframe. This menu is used to set the sources
going to each output.
Use the “Aux Bus” and “Crosspoint”” parameters to set the PGM, PVW and CLN outputs,
Normally, in HD format this would be O/P 1, 2 and 3 at the back of the mainframe.
Use the “Name” parameter to give the outputs a name i.e. 1 = Pgm, 2 = Pvw and 3 = Cln
Touch the “Crosspoint” popup and in the popup window, touch the Mixer O/P button and then
set “Output 1 as “Mixer O/P 1”, Output 2 as Mixer O/P 2 and Output3 as Mixer O/P3.
You can now setup all other sources for the Outputs.
To Next Page
Loading...
