146
Engineering, User & Panel Configuration
Modulation
All Start/ALL STOP - as described on the previous page, this function will set all the
modulation setups in the table to run or stop.
Detach - this will delete a selected modulation setup in the table.
Mixer Trans Group
These are modulators set to work with function in the Mixer Transition menu.
As can be seen below, modulators have been assigned to the “Wipe Modulation” H Amp, H
Freq and H Phase attachers.
Modulators within this group can also be assigned to work within the Bgnd DVE and Mixer DVE
functions.
To Next Page
Loading...
