90
Audio Setup
Using Masterpiece GUI Audio Menus
Stores (internal audio source)
Stores provide an internal audio source via the “Clipstore” function. Clipstores are pre-
configures clips of either just audio or audio with a bug/video clip.
There are 10 internal stores that can be used as a source to a crosspoint or provide a source for
a squeeze back macro.
The audio fader controls the audio level for the selected store. Touch one of the “Store” buttons
on the right to select the store that this menu will control. If the store is selected on a
crosspoint for example, adjusting the audio in this menu will adjust the audio level to the Main
Out only, the audio meter displays the audio level at the source and will not increase or reduce
when adjusting the audio fader. The fader provides some gain +10dB and attenuation (0dB to -
Inf).
Buttons:
Duck - selects whether a duck Level is applied to the selected Store.For the Store Audio
channel to have an effect on the program output attenuation level, when the Store Audio goes
to air, select the “Duck” assignment button.
Trans - selection will push the Preset Audio into the main audio transition
Reset - resets the fader to 0dB (can be overridden by Morpheus automation)
Cut On/Off - turn audio On/Off
Mix On/Off - mixes audio On/Off
Touching the menu expander will open the settings dialog box. Touch the {Assign} button, the
button will light up “light blue”. The function will be displayed when scrolling through the
function list using the toggle buttons. To enable the function touch the OLED button.
To Next Page
Loading...
