256
Macros
Offline Macro Editor
Edit an existing Macro using the Using Value and Details Parameters
There are two ways to edit a macro, the first is to change the value of a recorded action, this
means that the user can select an action in the recorded macro list and use the “Edit Value”
parameter to change the action of the macro.
For example, if a background crosspoint button was pressed as the macro action, the user can
use the “Edit Value” parameter to change the action to a different background crosspoint.
The second way is to use the Details menus which will display a different set of options
depending on the action selected; Do Trans, Next, Setup, Wipe and Time. These options allow
you to select a completely different action, i.e. change from selecting a background crosspoint
to selecting a Key within the selected action, time delays transitions, wipes etc.
The “Value” parameter and the “Delegate” options can be used to change actions within any
previously save macros in any file. This is done by simply selecting the File and Macro and
loading the macro within the “Macro Load” menu.
Wipe options
when using the
Details options
To Next Page
Loading...
