339
Masterpiece
User Manual
Peripherals - User
Tally Control
This menu allows the setup of a Tally serial port that is connected to an external devices. Tally
protocol supports 128 Source IDs.
Slot - selects the protocol that is currently being used
Extension Enable - this enables the Grass Valley extension in the protocol
ID - 1-84 are for BNC inputs and 85-128 are fixed, therefore greyed out.
Source - is the 120 BNC inputs, 84 Source IDs are not enough. So the users have to “choose”
which 84 out of the 120 BNCs they want to tally.
Any BNC that has not been assigned, an ID will not be tallied.
Default Source IDs button will reset the mapping table to be one to one mapped, i.e. ID 1 is
BNC 1, ID 2 is BNC 2 etc.
To Next Page
Loading...
