158
Engineering, User & Panel Configuration
Button Maps
Editing a Button Map
Touch one of the {Edit} buttons to get to the “Panel Config - Edit Button Maps” menu. When
the menu opens you can see that there are two tables, “Button” and “Source”, any changes
made on this page will happen in real time on the Mixer buttons.
The “Button” table is split into two columns, on the left are the “Primary” (unshifted) button
functions and on the right are the “Shifted” button functions.
The “Source” table is where the sources for the crosspoints are selected. The parameter controls
on the right are used to scroll through the buttons and to select the Primary and Shifted
crosspoints.
Button Number - this scrolls down the button numbers in the Button table.
Crosspoint - this scrolls through the User Defined and Fixed Crosspoints as displayed in the
Crosspoint Mapping menu. Touch the “Popup” button to quickly select a crosspoint option (as
shown below).
The Button Type parameter is used to select the overall function of the Bus button and has 3
options:
• Normal - the button selects the assigned primary and secondary sources.
To Next Page
Loading...
