298
Aux Buses
Aux Bus Overview
Setup an Aux Bus
To setup an Aux Bus, use the Aux Bus parameter to select the required Aux and the Crosspoint
parameter to select the source for the Aux Bus or use the pop-up list selector to quickly select
the required source. This sets the source that goes on each of the available outputs 1 to 14. You
can use the “Aux Name” parameter to give the output or Aux Bus a name.
The Lock parameters are used to lock out specific functions on an Aux panel.
The Panel Lock, lock out the selected crosspoint assigned to the Aux Panel so that when the
button is pressed, the crosspoint does not operate.
File Lock stops the user from loading a file.
When a Macro is attached to a crosspoint, the Macro Lock parameter disables the crosspoint
so that the attached macro cannot be triggered to run.
To Next Page
Loading...
