171
Masterpiece
User Manual
12G-SDI Output Setup
Setting up the UHD outputs on Masterpiece is very similar to setting up the inputs, where the
outputs are grouped in fours.
Touch the {Output Setup...} button and the menu will look like the one below.
Touch the OP1 row to select it, then set the “UHD Input” to {Yes}, the first 4 outputs are now
ganged together (see below), in the Grass Valleye way as the inputs, so now Outputs 1 to 4
make up the first UHD-quad output.
Set the “12G Output” parameter to “Ye s ” and the first 12G-SDI BNC can be connected to
output 1 (silver BNC). As the other outputs are setup as UHD outputs in the outputs table, the
12G Output parameter can be set to “Yes” for outputs 1, 5 and 9 (the silver BNCs).
Note: 12G-SDI setup - Notice that there is a parameter control called “12G
Output” This has to be set to “Yes” for each of the 12G-SDI outputs.
To Next Page
Loading...
