155
Masterpiece
User Manual
Display Server Timeout - This causes the touch screen GUI to go into sleep mode after a
designated amount of time. Default is 2 hours, maximum On time is 4 hours, can also be
disabled so the GUI is on constantly.
Delegate Confirmation - Not applicable to this product.
Panel Knob Reattachment - this function has 2 modes:
• Classic - the Key Control functions that work in conjunction with the Assignable Con-
trols will behave in the normal way.
• Safe - when using the Key Control functions in conjunction with the Assignable Con-
trols for Resize, Border, Mask and Bus Color, pressing the function button in the Key
Control area will make the button go Green, and the Assignable Controls will reflect
and adjust the selected function.
If a different function is selected, the previous function button used in the Key Control
area will remain Green, this allows the user to step back and forth between the selected
functions.
To switch the function off, press and hold the button, and the Green light will go off.
Name On Macro Buttons -
Snapshot
Remove On Hold - Touch and hold a “Macro” OLED button to create a snapshot. With the
“Remove On Hold” parameter set to “Yes”, touch and hold the OLED button again and the
snapshot is removed.
Overwrite - when a snapshot has been attached to a button, with this parameter set to “On”
you can press an hold the button and the original snapshot will be overwritten.
Sound On Write - when holding a OLED button down, the control surface will “bleep” to
indicate that a snapshot has been written.
Screen Coordinate System
The Screen Co-ordinate System is a tool by which the user can adjust the display of co-
ordinates on the GUI screen; co-ordinates that relate to the Resize engine, Mask areas and Wipe
positions.
Crop: The ability to set the crop positions into Screen Grid mode (as per Wipe/masks) to allow
the copying of Positions and Crops. To copy parameters “press and hold” the {Copy} button on
the GUI and select the parameter using the {Normal} button associated with that parameter.
Multiple parameters can be copied while copy button is held down, next go to the parameters
you want to paste these values too, hold down {Paste} and press the {Normal} button
associated with that parameter. The default mode for the Crop grid is percent.
Note: If you hold and remove the snapshot from the button, it also deleted
the snapshot from the Filing System.
To Next Page
Loading...
