168
12G-SDI Setup and Operation
Set the System up in UHD Mode
• FormatFusion3 for multi-format operations supporting HD, 1080p and UHD
• UHD supports Quad Link and 2SI
•Internal Stores
• 12G over SDI single link.
Set the System up in UHD Mode
As mentioned earlier, to use the 12G-SDI BNCs as UHD inputs and outputs, the mainframe has
to be placed into UHD mode.
The first step in enabling UHD mode is to put the GUI into the logged out state in the “Connect”
menu.
Touching the {Mainframe Config} button will open the “Mainframe Configuration” menu. In
the “Mainframe Configuration” menu, touch the {UHD} button to select UHD mode, then
press the {Up} button to go back to the “Connect” menu.
Finally, touch the {Switcher Login} button to log back into the Masterpiece operational menus.
Note: The “silver” BNCs on the Masterpiece Mainframe shown on the
previous page, these are the 12G-SDI Inputs and Outputs.
Note: Notice that when a touch screen GUI is connected to a
Masterpiece 12G-SDI mainframe, the logo in the bottom left corner of the
menu has “12G” under the Masterpiece name.
To Next Page
Loading...
