296
Crosspoints
Audio Shuffler
Automation Xpt
In this menu you can assign crosspoints to each bus when Masterpiece is under automation
control.
When the automation system sets a video/audio source on a Bus, Masterpiece will change the
Fill source of the automation crosspoint for that Bus. If the bus uses sources from an external
router, the user needs to go to the “External Router” menu to setup the router type, slot, matrix
and level. And make sure “External” is on. If “External” is off, the bus will use internal sources.
If the automation system sets a bad/incorrect source on a Bus, the user can manually override
this crosspoint. Masterpiece will reassign the automation crosspoint to the bus for the next
event. Each bus should have its own automation crosspoint.
To Next Page
Loading...
