351
Masterpiece
User Manual
Peripherals - Editor Control
This function allows external equipment software to control some functionality on
Masterpiece, such as the Crosspoint selection, DMEM's, Transition Control.
Before using this protocol the required DMEM that are going to be used with the external
equipment software should have been saved into the “Default” file on the Masterpiece
mainframe. This will enable external equipment software to recall the required DMEM.
The Snapshot Recall parameter should be set to “Auto” allowing the external equipment
software to recall DMEM, but the user can also set the parameter to only allow DMEMs to be
selected.
Crosspoint Selection
Note: This example the GVG 100 Control protocol will be used.
Note: GVG 100 Control protocol directly drives linked Mixer parameters for
Bus Control and Transition Control.
To Next Page
Loading...
