iPECS UCP600 - Page 156

iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
142
Table 4.4.5.1-1 SYSTEM ATTRIBUTES
ATTRIBUTE
DESCRIPTION
RANGE
DEFAULT
SLT Line Monitor
Time
The system monitors if SLT Line functions correctly at a preset
time in this field.
0-23
0
UCS Ring ACK
Count
UCS Client can be checked by Ring ACK Message. If the Ring
ACK message is sent and gets no ACK message, the system
sets the state of UCS Client on OOS(Out of service) after the set
of Ring ACK count.
If the Ring ACK Count is 0, the UCS Client goes to OOS (Out Of
Service) after 1 time. If the count is 2, UCS Client can go to
OOS (Out Of Service) at 3 times.
UCS Client is ringing before expiring the Ring ACK timer set on
System Timers ‘UCS Ring ACK Timer’ and afterward will hear
Error tones.
0-9
0
Dial Back to
Caller from
Remote VM
Access
A user accesses voice mail from a remote. The user can make a
call to the caller of the voice mail like below.
If ‘Toll-Free’ is selected, the user can call the caller of the voice
mail. If ‘toll check’ is selected, Station COS will be applied. If
‘Rejected’ is selected, the user can’t call the caller of the voice
mail.
Toll Free, Toll Check, Rejected
Refer to
description
Toll Free
Web Admin
Login Failure
count to block
For security, the administrator can set the limited count to log in
to Web admin from 5 to 63.
5-63,
0(unused)
5
Web Admin
Hacking Block
Period
This setting time is the duration of blocking the access to Web
admin if Web admin login fails.
5-60
minutes
5
Web Admin
Hacking Block
Email Notification
If this option is enabled, System sends the notification by email
about blocking the web admin. The email address is following
the below ‘Alarm Receiver E-Mail Address(To) & Notification
Receiver E-Mail Address(To)’.
Disable,
Enable
Disable
RTP/SRTP
SSRC filtering
It is used to remove noise by SSRC filtering.
LIP phone could be locked up if the LIP-9002/9008/9008G
version is lower than 1.2Aa when enabled.
Disable,
Enable
Disable
USB serial usage
It should be enabled when a USB terminal is used.
vUCP/eMG100 is not available for this feature.
Disable,
Enable
Disable
Display Forward
Reason
This option shows the forward reason and the original station
number for an external call on the upper part of the LCD by
setting ON. The related PGM are as below:
 The normal forward from Station to Station.
 The value 'Attendant' is checked in 'DID/DISA Destination
(167)'.
 The type 'Attendant' is selected in 'CCR Table (228)'.
 'Reroute Destination' is selected 'Station' in 'Flexible DID
Conversion (231)'.
OFF
ON
OFF