iPECS UCP600 - Page 535

iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
94
Table 3.3.3.2-1 STATION ATTRIBUTES I (PGM 111)
BTN
ATTRIBUTE/DISPLAY
DESCRIPTION
RANGE
DEFAULT
9
100-110 SPKR/HEAD
(1:SPKR/0:HEAD): SPKR
Selects Speakerphone mode or Headset
mode
0: Headset
1: Speaker
SPKR
10
100-110 LCD DISP LED
(1:RING/0:MWI): MWI
The LCD LED, upper left of LCD, may be
used for Intercom Call ring Indication or
Message Wait Indication.
0: MWI
1: Ring
MWI
11
100-110 LOOP LCR ACCT
(1:ON/0:OFF) : OFF
Station based LOOP LCR authorization; is
used for LOOP LCR operation.
0: OFF
1: ON
OFF
12
100-110 CALL COVERAGE
(1:ON/0:OFF) : OFF
The Call Coverage feature permits an iPECS
Phone user to receive ring and answer calls
to other stations.
0: OFF
1: ON
OFF
13
100-110 CALL COVERAGE
DELAY RING: 0
When a covered station rings, the {CALL
COVERAGE} button LED will flash at the
covering station and will receive a ring
(immediate or delayed 0 to 9 ring cycles).
0~9
0
14
100-110 OFFNET FWD
(1:DIS/0:EN):ENABLE
A station must be allowed Off Net Fwd to
forward external incoming calls outside the
system or otherwise establish a CO-to-CO
connection (Unsupervised Conference).
(Except USA version)
0: Enable
1: Disable
Enable
15
100-110 FORCED ICM
(1:ON/0:OFF) : OFF
When placing an intercom call, a user can
change the ICM signaling mode, Tone Ring
to Hands free answer mode, or HF Answer to
Tone Ring.
0: OFF
1: ON
OFF
16
100-110 ACT PTT GRP
ACTIVE PTT GROUP:
A station can be assigned to a PTT group,
and the group is enabled so the station can
place and receive PTT announcements for
the group.
0~9
.
17
100-110 ICM GROUP
(01-15): 01
Assigns station to an ICM Tenancy Group,
refer to PGM 125.
eMG80/100:1~15, eMG800:0~32
Refer to
description
1
18
100-100 VMIU/VMIB
BOARD
USE 1ST VMIU/VMIB
Assigns the VMIU or VMIB where messages
for the station are stored.
Sequence
number.
19
100-110 SIP UID TBL
(000-140) : 000
Index to SIP User ID table, PGM 126, for the
station. Note PGM 126 is accessible Web-
only.
000-140
000
20
100-110 CAMP ON TONE
(1:ON/0:OFF) : ON
Permits camp-on tone to be sent to a station
when the station receives camp-on request.
0: OFF
1: ON
ON