iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
96
Table 3.3.3.2-2 STATION ATTRIBUTES II (PGM 112)
100-110 CO/IP QUEUING
(1:EN/0:DIS): ENABLE
Permits the station to queue for the next
available Line when all Lines Busy signal is
received.
100-110 CO PGM
(1:EN/0:DIS): DISABLE
A station can be permitted to change the CO
Line numbers(ports) associated with a
COLine button.
100-110 RING LINE PRE
(1:EN/0:DIS) : ENABLE
Enables Ringing LinePreference for the
station. Calls that ring the telephone are
answered by going off-hook.
100-110 SPD ACCESS
(1:EN/0:DIS) : ENABLE
Allows the station assessment to system
Speed Dial bins.
100-110 UCD GRP SVC
(1:ON/0:OFF) : OFF
When unavailable, DID/DISAcalls to the
station can be routed to the ACD Group to
which the station is a member.
100-110 RING GRP SVC
(1:ON/0:OFF) : OFF
When unavailable, DID/DISAcalls to the
station can be routed to the Ring Group to
which the station is a member.
100-110 TWO WAY RECD
(1:ON/0:OFF) : OFF
When allowed, the station can activate the
Two-way record feature to record a
conversation.
100-110 MSG SCRL SPD
(0 - 7) : 3
Select message scroll speed for IP phone
(Notpresently used).
100-110 HOT DESK STA
(1:ON/0:OFF) : OFF
A station can be assigned as a Hot Desk
phone. Users and agents can log in and use
resources of the system through the Hot
Desk phone.
100-110 PREFER CO/GRP
…..
The system will seize this COLine or CO
group number when the station dials ‘9’ (The
first available CO access code).
100-110 SEND SLT CLI
(1:ON/0:OFF) : ON
When allowed, system will sendCLI
information to the SLT.
100-110 UCD PRIORITY
(0-9) : 0
ACD Group members may be assigned a
priority, 0-9. Members with the highest
priority are sent calls ahead of lower priority
members. This field is the same as PGM191-
button 19 for ACD Groups.