iPECS UCP600 - Page 541

iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
100
Table 3.3.3.2-3 STATION ATTRIBUTES III (PGM 113)
BTN
ATTRIBUTE/DISPLAY
DESCRIPTION
RANGE
DEFAULT
21
100-110 BY PASS DTMF
(1:ON/0:OFF) : OFF
When detected, DTMF from an SLT may be
regenerated by the analog CO line ports. The
SLT port can by-pass detection, so DTMF is
not detected.
0: OFF
1: ON
OFF
22
100-110 PROCTOR MONIT
(1:ON/0:OFF) : OFF
Enables to use of PABX ANI Link device for
E-911 supporting. Only an SLT can be used
for this feature.
0: OFF
1: ON
OFF
23
100-110 VSF MailSvrID
………………………
The VMIU and VMIB include notification of
new messages to the user’s voice mail. This
field defines the user’s ID to notify when a
new message is received at the VMIU or
VMIB.
24
ADDED STATION ATT3
PRESS FLEX KEY (01-24)
01-24
24-1
100-110 VSF MailSvrPW
………………………
Unified Mail server password
24-2
100-110 DOOR OPEN
(1:EN/0:DIS) : ENABLE
Enables use of Door open feature by the
station - Default value :
Australia: Disable except for port 1or2
Otherwise: Enable
0: Disable
1: Enable
Enable
24-3
100-110 VSF MSG DD/TM
(1:ON/0:OFF) : ON
When ON, play the date/timestamp of VSF
message.
0 : OFF
1 : ON
ON
24-4
100-110 OGM DEST
NOT ASSIGNED
Assign Mail box destination. When a user
dials the attendant code(‘0’ or ‘9’), if it is
assigned, then the call will be delivered to the
assigned mail box destination instead of the
attendant. If it is not assigned, then the call
will be delivered to the attendant.
Not
Assigned
24-5
100-110 VSF DEL MSG
(1:ON/0:OFF) : OFF
When ON, delete VSFmessages when send
UMSe-mail notification.
0 : OFF
1 : ON
OFF
24-6
100-110 VM PWD CHECK
(0-2) : STN&PWD
When ON, check the password when the
user accesses the VSF messages.
 0: No Password
 1: PWD only
 2: station number and Password
Refer to
description
station
number
and
Password