iPECS UCP600 - Page 547

iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
106
Table 3.3.3.3-1 STATION ISDN ATTRIBUTES (PGM 114)
BTN
ATTRIBUTE/DISPLAY
DESCRIPTION
RANGE
DEFAULT
23
100-110 P-MSG LANG
(1-6):PROMPT1 U.S
Select a voice-enabled preselected
message for a station playing toward an
incoming CO call. The range is as below
1: US, 2:KOREA, 3:TURKIYE
4:RUSSIA, 5:AUTRALIA, 6:GERMANY
Refer to
description
1
24
ADDED STATION ATT4
PRESS FLEX KEY (01-23)
24-1
100-110 STN CLI 2
…………....
Station CLI 2 can be programmed. If a CO
line is set to Station CLI 2, then this CLI is
used for outgoing CLI.
16 Chars
None
24-2
100-110 STN CLI 3
…………....
Station CLI 3 can be programmed. If a CO
line is set to Station CLI 3, then this CLI is
used for outgoing CLI.
16 Chars
None
24-3
100-110 STN CLI 4
…………....
Station CLI 4 can be programmed. If a CO
line is set to Station CLI 4, then this CLI is
used for outgoing CLI.
16 Chars
None
24-4
100-110 STN CLI 5
…………....
Station CLI 5 can be programmed. If a CO
line is set to Station CLI 5, then this CLI is
used for outgoing CLI.
16 Chars
None
24-5
100-110 SLT CID TYPE
(0:FSK./1:DTMF) : FSK
SLT can send CID by programming
options.
0:FSK
1:DTMF
FSK
24-6
100-110 WAKEUP ANNC
00
Wakeup Announce can be programmed.
0-200
0
24-7
100-110 CAMP ON ENABLE
(1:ON/0:OFF ) : ON
If it is ON (enabled), then this station will
receive camp on. But if it is OFF(Disabled),
then this station will not receive camp on by
another person.
0: OFF
1: ON
ON
24-8
100-110 GAIN TBL
(1-3) : 1
TDM gain table can be programmed.
1-3
1
24-9
100-110 TONE TBL
(1-5) : 1
Tone table can be programmed.
1-5
1
24-10
100-110 DGT CONV TBL
(01-15) : 00
Set the digit conversion table.
eMG80/100:1-15, eMG800/UCP:1-32
Refer to
description
0