iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
122
4.3.3.14 ICM Tenancy Group – PGM 125
Stations can be assigned to an ICM Tenancy group under Station Attributes II PGM 111, button 17. Up to 15
Tenant groups for eMG80/100 and up to 32 for eMG800 can define. Each group is configured to allow or deny
placing intercom calls to stations in other groups, and an Attendant station can be defined for each group. The
Attendant will receive “dial 0” calls and controls Day/Night mode for the Group.
ICM TENANCY GROUP
ENTER GRP NUMBER (01-15)
Press the [PGM] button and dial 125.
ICM TENANCY GRP 01
F1:ATD F2:ACCESS
Use the dial-pad to enter the group number (Ex. 01)
Press the desired Flex button; refer to Table 3.3.3.14-1.
For the Attendant assignment, use the dial-pad to enter the station number
of the Group Attendant.
To assign the accessible ICM Tenancy groups for the group, the Flex
button indicates the current Tenant group access. Press the Flex.
Buttons to toggle the Group access settings.
- LED ON: group access allowed
- LED OFF: group access denied
Press the [Save] button to store the data entry.
Table 3.3.3.14-1 ICM TENANCY GROUP ATTRIBUTES (PGM 125)
ICM TENANCY GRP 01
ATD: . . . .
It is an Attendant station for the ICM
tenancy group. ATD receives dial ‘0’ calls
and controls Day/Night mode.
ICM TENANCY GRP 01
PRESS ACCESS GRP(1-15)
ICM Tenancy groups allowed access to
the selected group.
eMG80/100:01-15, eMG800/UCP:01-32
4.3.3.15 Station VM Attributes – PGM 127
Voice Mail attributes can be assigned on a station basis. The description and valid inputs are given in Table
3.3.3.15-1.
Press the [PGM] button and dial 127.
STATION VM ATT
ENTER STA RANGE
100-110 STA VM ATT
PRESS FLEX KEY (01-20)
Press the desired Flex button.
Use the dial-pad to enter desired data. Refer to Table 3.3.3.15-1.
Press the [Save] button to store the data entry.
To Next Page
Loading...
