iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
146
4.3.5.6 CO Line Preset Forward Attributes – PGM 147
The CO Line Preset Forward feature enables a CO line to initially ring at multiple stations and forward to a
pre-determined destination (PGM 204).
The destination can be a station, Voice Mailbox, ACD group, or Hunt group. Each CO line has a Preset
Forward Timer. Each CO line can also be assigned a VMID (Voice Mail Id) to send specific VM digits when a
CO line forwards to an external VM group.
CO PRESET FWD ATT
ENTER COL RANGE
Press the [PGM] button and dial 147.
01-02 CO PRE-FWD
PRESS FLEX KEY(1–3)
Use the dial-pad to enter the CO Line range. For a single CO Line, enter the
same number twice.
Select the desired Flex button; refer to Table 3.3.5.6-1.
Use the dial-pad to enter the desired value for the selected Attribute. Refer to
Table 3.3.5.6-1.
Press the [Save] button to store the data entry.
Table 3.3.5.6-1 CO LINE PRESET FORWARD ATTRIBUTES (PGM 147)
01-02 PRESET FWD TMR
(00-99 SEC) : 00
An incoming call, which remains
unanswered for this timer, is routed to the
pre-determined Ring Table Index, PGM
147-button 2.
01-02 RING TBL INDEX
INDEX : NOT ASSIGNED
If an incoming call remains unanswered
after the Preset Fwd time, the call is
routed as defined in the ICLID Ring
Assignment table bin entered here. Refer
to PGM 204.
Each CO/IP line can be assigned a VMID
(Voice Mail Id) that is sent to the VM
group to identify the desired Mailbox for
the CO/IP line.
To Next Page
Loading...
