iPECS UCP600 - Page 600

iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
159
Table 3.3.6.1-1 SYSTEM ATTRIBUTES I (PGM 160)
BTN
ATTRIBUTE/DISPLAY
DESCRIPTION
RANGE
DEFAULT
24-1
SIP STA MODE
(1:PTP/0:RTD): RTD
SIP phones may set-up apoint-to-point
RTP connection(PTP) or to assure a
controlledconnection, RTP can be
routedvia a VoIP channel (RTD).
0: RTD
1: PTP
ROUTED
24-2
SYS AUTH END CODE(#)
(1:ON/0:OFF) : OFF
If this value is set to ON, the end dialing
digit (#) must be entered when the system
Auth code is entered.
0: OFF
1: ON
OFF
24-3
STN VM FEATURE USAGE
(1:ON/0:OFF) : ON
If this value is set to ON, the Station VM
feature (PGM127) can be used.
0: OFF
1: ON
ON
24-4
REMOTE VM ACCESS
(1:ON/0:OFF) : ON
If this value is OFF, the user cannot
access their VSFmailbox via DID, DISA
CO call, and so on (i.e., through CO line
channel).
0: OFF
1: ON
ON
24-5
TRANSFER TONE USAGE
(1:ON/0:OFF) : OFF
If this value is ON, a Warning tone is
served to the [transfer to]station. It is only
applied to screened transfer cases.
0: OFF
1: ON
OFF
24-6
LCR DIAL TONE DETECT
(1:ON/0:OFF) : OFF
If this value is set to ON, the system first
checks if the CO provides dial tone in
case if analog CO is seized for LCR
dialing. If there’s no dial tone, the call is
rerouted to Alternate DMT Index.
If the LCR type is set to M13, the LCR dial
tone detect option is not applied.
0: OFF
1: ON
OFF
24-7
ICM CALL LOG
(1:ON/0:OFF) : OFF
If this value is set to ON, the system
saves and provides ICM call log for IP and
LDP phones.
0: OFF
1: ON
OFF
24-8
ATD PWORD USAGE
(1:ON/0:OFF) : OFF
If this value is set to ON, the system
requests the password below cases.
When a user enters attendant
program([PGM] + 0) in attendant keyset,
When a user enters the speed program in
the attendant keyset,
When a user assigns attendant program
code([PGM] + 0) to flexible button in the
attendant keyset,
0: OFF
1: ON
OFF
24-9
PICKUP STA NAME USAGE
(1:ON/0:OFF) : OFF
Name of picked up station is display when
pickup internal call.
0: OFF
1: ON
OFF
24-10
DISPLAY LCR MODE
(1:ON/0:OFF) : ON
Display “LCR MODE” when LCR is
activated.
0: OFF
1: ON
ON