iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
162
Table 3.3.6.1-2 SYSTEM ATTRIBUTES II (PGM 161)
BASE CODEC TYPE
(0-3): G.711(0)
The default codec can be defined as
G.711 or G.723.1 for decreased
bandwidth needs. The selected codec will
be used on all internal communications as
well as for remote iPECS devices.
0: G.711
1: G.723.1
2:G.729
3:G.722
G711 PACKETIZATION(1ms)
(10/20/30) : 20
The G.711 voice frame packetization time
determines the interval at which voice
samples are packetized and sent when
the G.711 codec is used.
G723 PACKETIZATION(1ms)
(30/60) : 030
The G.723.1 voice frame packetization
time determines the interval at which
voice samples are packetized and sent
when the G.723.1 codec is used.
NETWORK TIME/DATE
(0-2) : DISABLE
The system can use ISDN Network time
or NTP to synchronize time with the ISDN
or data network. To disable time sync, use
OFF. ISDN sync is not available in the
USA version.
INCOMING TOLL CHK
(1:ON/0:OFF) : ON
The system can invoke COS dialing
restrictions when a user dials while
connected to the incoming call.
WEB SERVER PORT
(00001-65535) : 00080
This field determines the TCP port
employed to access the system WEB
server.
OLD AUTH CODE USAGE
(1:ON/0:OFF) : ON
The user enters system Authorization
codes as “*” and the code (ON) or “*”+ the
Auth code index and the code (OFF).
COS 7 WHEN AUTH FAIL
(1:ON/0:OFF) : OFF
If a user fails to enter a valid Authorization
code in the number of attempts assigned
in FAC RETRY COUNT, PGM 160-button
16, the station is disconnected, or the
Station COS is changed to COS 7. In the
latter case, the user must employCOS
Restore in Station User PGM 2 to return
the station to the normal COS.
UNIFIED MESSAGE FORMAT
(1:ON/0:OFF) : OFF
System Integration Messages are sent out
the defined serial or TCP channel.
To Next Page
Loading...
