iPECS UCP600 - Page 635

iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
194
4.3.6.20 System Timers I to III - PGMs 180-182
A number of timers can be assigned to control and affect many features and functions of the system. Refer to
Table 3.3.6.20-1 to Table 3.3.6.20-3 for a description of the timers and the input required.
PROCEDURE
SYSTEM TIMER 1
PRESS FLEX KEY (01-22)
Press the [PGM] button and dial:
- 180 for System Timers I
- 181 for System Timers II
- 182 for System Timers III
Press the Flex button for the desired Timer; refer to Table 3.3.6.20-1 ~3.
Us the dial pad to enable or disable the desired language prompts.
Press the [Save] button to store the data entry.
Use the dial-pad to enter the desired Timer data. Refer to Table 3.3.6.20-1~3.
Press the [Save] button to store the Timer data entry.
Table 3.3.6.20-1 SYSTEM TIMERS I (PGM 180)
BTN
ATTRIBUTE/DISPLAY
DESCRIPTION
RANGE
DEFAULT
1
ATD RECALL TMR(min)
(00-60) : 01
Determines the amount of time the
attendant receives recall, after which the
system will disconnect the call.
00~60
minutes
01
2
CALL PARK TMR(sec)
(000-600) : 120
Determines the amount of time before a
parked call will recall the station that parked
the call.
000~600
seconds
120
3
CAMP-ON RECALL TMR(sec)
(000-600) : 030
When a call transfer is camped on, this
timer determines the amount of time before
the station receives a recall.
000~600
seconds
030
4
EX-HOLD RECALL TMR(sec)
(000-600) : 060
Determines the amount of time before a call
placed on exclusive hold will recall the
station.
000~600
seconds
060
5
I-HOLD RECALL TMR(sec)
(000-600) : 030
Determines the amount of time before a call
that is recalling the station will recall before
also recalling the attendant.
000~600
seconds
030
6
S-HOLD RECALL TMR(sec)
(000-600) : 030
Determines the amount of time before a call
placed on system hold will recall the
station.
000~600
seconds
030
7
TRANS RECALL TMR(sec)
(000-600) : 030
Determines the amount of time a
transferred call will ring at the receiving
station before recalling the station that
transferred the call.
000~600
seconds
030
8
ACNR DELAY TMR(sec)
(000-300) : 030
If the ACNR Pause Timer expires and no
CO Line is available for ACNR recall, the
delay timer sets the delay before ACNR
attempts to access a CO line. The retry
counter is not decremented by this action.
000~300
seconds
030