iPECS UCP600 - Page 639

iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
198
Table 3.3.6.20-2 SYSTEM TIMERS II (PGM 181)
BTN
ATTRIBUTE/DISPLAY
DESCRIPTION
RANGE
DEFAULT
20
BUTTON IDLE TMR(1sec)
(00,10-99) : 00
When a button is pressed, an auto-idle
timer is added. A button is pressed in an
idle state, and it goes to a menu list state.
(not calling state)
In the menu list state, this auto-idle timer
is applied.
The button that is applied to this timer is
as below.
- 1. Transfer / PGM.
- 2. Speed.
- 3. Menu.
- 4. Directory.
- 5. Message.
- 6. Call Log.
00,10~99
(1 sec.)
00
Table 3.3.6.20-3 SYSTEM TIMERS III (PGM 182)
BTN
ATTRIBUTE/DISPLAY
DESCRIPTION
RANGE
DEFAULT
1
SLT HOOK BOUNCE(100ms)
(01-25) : 01
This timer determines the duration the
system considers an actual state change
in the hook-switch and not a spurious
contact bounce.
01~25
(100msec.)
01
2
SLT MAX H_FLASH(100ms)
(01-25) : 07
This timer sets the maximum time an SLT
user can depress the hook-switch for a
Flash signal.
01~25
(100msec.)
07
3
SLT MIN H_FLASH(10ms)
(000-250) : 010
This time sets the minimum time an SLT
user must depress the hook-switch for a
Flash signal.
000~250
(10 msec.)
010
4
STA AUTO RLS TMR(sec)
(000-300) : 060
The system will return a station to idle for
an internal call if the call remains
unanswered for this duration.
000~300
(seconds)
060
5
UNSUPER CONF TMR(min)
(00-99) : 10
This timer determines an “Unsupervised
conference” duration before the station is
recalled or the conference is dropped.
00~99
(minutes)
10
6
PRIME LINE TMR(sec)
(01-20) : 05
This timer sets the delay (no action
duration) for delayed Prime Line
operation.
01~20
(seconds)
05
7
WINK SIGNAL TMR(10ms)
(010-200) : 010
This timer sets the duration of the “Seize
Acknowledge Signal” (Wink) sent to the
PSTN on a DID line.
010~200
(10 msec.)
010