5 Open the bottom ADF door, and then remove any jammed pages.
1
2
6 Close the bottom ADF door and scanner cover.
7 To uc h Restart Job.
29y.xx error messages
Error code Description Action
290.00 Media remains on the sensor (ADF sheet through)
during the warm up sequence.
Go to
“Sensor (ADF sheet through) static jam
service check” on page 167.
290.01 The media does not reach the sensor (ADF sheet
through) within the specified time.
Go to
“Sensor (ADF sheet through) late jam
service check 290.01” on page 168.
290.02 The media does not reach the sensor (ADF 1st scan)
within the specified time.
Go to
“Sensor (ADF 1st scan) late jam service
check” on page 172.
290.03 The media reached the sensor (ADF sheet through)
but did not clear it within the specified time.
Go to
“Sensor (ADF sheet through) lingering
jam service check” on page 170.
290.10 Media remains on the sensor (ADF 1st scan) during
the warm up sequence.
Go to
“Sensor (ADF 1st scan) static jam service
check” on page 173.
291.00 Media remains on the sensor (ADF 2nd scan) during
the warm up sequence.
Go to
“Sensor (ADF 2nd scan) static jam service
check” on page 174.
291.01 The media does not reach the sensor (ADF 2nd
scan) within the specified time.
Go to
“Sensor (ADF 2nd scan) late jam service
check” on page 177.
291.02 The media does not reach the sensor (ADF media
exit) within the specified time.
Go to
“Sensor (ADF media exit) late jam service
check” on page 181.
292.00 The ADF top door assembly was opened while the
ADF was operating.
Go to
“ADF top door open jam service check”
on page 178.
293.00 The media is removed from the ADF once the feed
process is initiated.
Go to
“Media missing jam service check” on
page 179.
7462
Diagnostic information
165
To Next Page
Loading...
