Mitel 430 - Other Routing Functions for Outgoing Calls

Routing elements
115
System functions and features as of R4.1
syd-0570/1.2 – R4.1 – 08.2016
Note:
In the case described above, the parameter Trunk line selection mode is set to Linear
(default setting). For some cases it may be useful to set the parameter to Cyclic. The system
detects the exchange line on which the last call was made and tries to make the next call on the
next exchange line.
If both analogue and digital network interfaces are being used, one trunk group has to
be entered in each route for the analogue interfaces and one trunk group for the digital
interfaces since a trunk group can only contain either analogue or digital interfaces.
Default settings
• After initialization, route1 is allocated trunk groups 1 and 2.
• After initialization, route 3 is allocated trunk group 1
(route for remote alarming).
• With Mitel 415/430 all routes are allocated numbers from 170 upwards in the num-
bering plan.
• On the Mitel 470 system the first 24 routes are allocated numbers from 170 upwards
in the numbering plan.
Mitel Advanced Intelligent Network:
In an AIN the local network interfaces of nodes can be prioritised for each route (parameter
Use own node network interfaces first). This allows outgoing calls from DECT cordless
phones to PISN users or integrated mobile/external users to be routed primarily via the sys-
tem’s own network interfaces, thereby saving VoIP resources.
5. 3. 3 Other Routing Functions for Outgoing Calls
Restricting Calls Outgoing Simultaneously
The Max. outgoing calls setting is used to specify the number of outgoing calls that
are possible simultaneously. Once the limit has been reached, users can no longer
make outgoing calls with the allocation of this route. This is signalled by means of the
congestion tone.
Activating/deactivating external digit barring
Normally an outgoing call is compared with the external digit barring allocated in the
user configuration.
Deactivating the External digit barring setting deactivates the external digit barring
for each route. This is useful when a route is set up for calls into the private leased-line
network.
Deleting the exchange access prefix
If the call number of an outgoing call has an exchange access prefix, it will be trun-
cated before the call is forwarded.