Mitel 430 - Fast Take (Pick up a Call or a Call Connection)

Features
431
System functions and features as of R4.1
syd-0570/1.2 – R4.1 – 08.2016
User A has set up a call connection with user B, who transfers the call to user C’s cord-
less phone by pressing a key. Caller A is not aware that the call has been transferred.
Detailed Description
Tab. 257 Take (taking a call)
System configuration
Tab. 258 Take: Key configuration
Tip:
Take is actually nothing other than the preparation for accepting a call and accepting the call
from the same terminal. This function can be carried out more simply using the Fast Take fea-
ture.
Reference to Other Features
"Acceptance of a call or data connection:", page 428
"Fast Take (pick up a call or a call connection)", page 431
9. 6. 26 Fast Take (pick up a call or a call connection)
The Fast take function combines and expands the two features Take a call and Pick up
a call:
Fast Take allows an internally authorised user C
• to take an existing call connection between the internal or external user A and an in-
ternal user B.
• to pick up and therefore answer the incoming call from user A to user B.
• to take the outgoing call from user B to user A even before user A has answered the
call.
End point Operating sequence / signalling on the terminal
C Activating via the configurable key on the cordless phone
Function type Note
On the cordless phone the following command is
used to prepare a configurable key to allow user
C to take over user B’s call:
I *87 B * C # X I *88 #
Requirement:
The Prepare call acceptance authorization must be enabled with
user C.
Restriction:
Only simple connections can be accepted, not conferences, users
on hold, etc.