Mitel 430 - Release Destination if Dialling Is Incomplete

Call routing
189
System functions and features as of R4.1
syd-0570/1.2 – R4.1 – 08.2016
Call destination: Busy User Group
A user group is busy if all its members are busy, if call waiting is rejected, if call waiting
is not enabled for any of the user group members and if neither the element operator
console nor the element general bell is activated.
If a user group is busy, an incoming call is routed to user group 16.
If Call waiting is not enabled for any of the members of user group 16, the caller is ob-
tains busy tone.
Call destination: Busy KT Line
If an incoming call is routed to a busy KT line, the call will be rejected and the caller ob-
tains the busy tone.
Call destination: User with a Stored Message
If a user has stored a message, an incoming call will be routed to the preconfigured
Call Forwarding Unconditional destination.
If a preconfigured call forwarding unconditional destination has not been defined, the
user will be called nonetheless.
6. 3. 7. 2 Release Destination if Dialling is Incomplete
If the direct dial number is incompletely dialled, the outside call will be routed to the call
destination element allocated to the trunk group after 8 seconds and then forwarded to
the destinations entered there.
Scope
Valid only if the network provider transmits the digits of the direct dial numbers using
the overlap receiving method. If the direct dial numbers are transmitted using the en-
bloc method, an incomplete direct dial number will never be transmitted to the commu-
nication server.
Mitel Advanced Intelligent Network:
In an AIN the availability of Capolinea depends on the Master settings. If the Country parameter
is configured to IT on the Master, Capolinea is available throughout the AIN.