Call logging (CL)
277
System functions and features as of R4.1
syd-0570/1.2 – R4.1 – 08.2016
8. 3. 5 Charge management
If an external call is forwarded internally, the charges incurred can be passed on to the
next user. The charge management can be activated and deactivated throughout
the system and applies only locally in the PINX.
User A is making an outside call. After a while he hands the call over to user B.
Fig. 151 Handing over the call charges from user A to user B
If charge management is switched on, the charges incurred by user A during the call
are passed on to user B when the call is handed over. User A therefore does not incur
any charges.
The total amount of 7.– is charged to user B on the ICC and the OCL.
If charge management is switched off, an intermediate statement is drawn up for user
A when the call is handed over. It contains the charges incurred by user A up to the
point at which the call is passed on (5.50). This means that user B incurs only those
charges levied from the point at which the call is handed over to him (1.50).
On the operator console, call charges are always passed on to the next user irrespec-
tive of whether or not charge management has been configured.
8. 3. 6 Virtual charges
You have the possibility of setting up virtual charge counting for exchange line circuits
that do not provide call charge information (e.g. SIP). To do so, enter the charge pulse
interval in seconds in the route configuration using the parameter Pulse interval for
virtual charges. The charge pulse value is defined with the general charge settings
( =b4). In the default setting no virtual charges are logged.
Example:
Route 1: Pulse interval for virtual charges: 20 seconds).
General charge settings Charge value: EUR 0.10
An outgoing call via this route generates virtual charges of 30 cents a minute.
0.– 5.50 5.50 7.–
5.50 1.50
To Next Page
Loading...
